51
B15 Darning
z Attach the automatic buttonhole foot R and pull the
button holder all the way out.
x Start the machine and sew to the required length, then
press the reverse button. This sets the darning length.
Continue sewing until the machine stops automatically.
q Required length
c Sew another layer of darning over the first layer, at a
right angle to it.
NOTE:
The maximum darning length is 2 cm (3/4”) and the
maximum width is 0.9 cm (3/8”).
To sew the same size darning
When finished sewing, a confirmation message will
appear.
Simply start the machine to sew another darning in the
same size.
To sew the next darning in a different size, press the X
key.
To sew a shorter darning
Sew the first line to the desired length and stop the
machine.
Press the reverse button and start the machine again.
The machine will sew the rest of the darning and stop
automatically.
To adjust the evenness of darning stitches:
You can correct unevenness of darning stitches by
pressing the “–” or “+” key in the adjusting window.
If the left corner is lower than the right side, press the “–”
key to correct it, and vice versa.
z
x
c
q
0.9 cm
To Next Page
Loading...
