9
６.０mm
Mechanical Adjustment
The distance between the bottom of the presser foot in up position and the needle plate should be 6.0 mm.
Presser bar height
1. Remove the face plate and needle.
2. Lower the feed dog below the needle plate. Place a block 6 mm thick under the presser foot and lower the
presser foot lifter.
3. Loosen the setscrew . Raise the presser foot lifter and tighten the setscrew firmly.
Attach the needle and face plate.
NOTE:
Make sure that the presser foot should be parallel to the feed dog slots in the needle plate.
q
q
w
w
Presser foot should be
parallel to the feed dog slots.
q
To Next Page
Loading...
