3-2-8 JPU-504/JPU-1004, Unit Type
Use the keyway provided on the bottom of the Electro Press to eliminate thrust play with a pin
matched to the keyway width.
Fix the Electro Press to the mounting base at the screw holes using 4 M12 hexagon socket bolts
(JIS Strength 12.9, Length 45 mm or more) and washers. Tighten the bolts to 120 Nm tightening
torque.
Fit the switch box to the Electro Press with 4 screws (M4) using the screw holes on the rear of the
unit.
(Keyway Width)
(Mounting Part Thickness)
(Keyway Depth)
(Mounting Screw Hole)
Switch Box (Rear)
Setup Electro Press JP Series 4 16
To Next Page
Loading...
