5. HOW TO INSTALL PRESS SYSTEM SOFTWARE
The Electro Press is controlled by built-in “Press system software.” To upgrade the press
system software, follow the instructions below. (For this operation, the machine must be
connected to a PC.)
“Press system software” is included in the Operation Manual CD-ROM with the file name,
JpSyp_XXX.jsy. (“XXX” indicates the version number.)
1. Turn OFF the machine, remove the cover on the rear body (Stand-anole/Head type) or the
cover on the control box (front) (Unit type.) Turn the special mode switch ON.
Inside the Cover
Special Mode Switch
Body (Rear),
Stand-Alone/Head Type
Control Box (Front), Unit Type
Setup Electro Press JP Series 4 36
To Next Page
Loading...
