85
Cleaning the Inside of the Thread Guide
Clean the inside of the thread guide plate under the top
cover at least once a month.
z Remove the needle thread and remove the thread
guide plate by pulling it up.
q Thread guide plate
q
e
x Remove lint and dust from the brush on the underside
of the thread guide plate using a lint brush.
w Brush on the thread guide plate
c Clean the area around and under the pre-tension leaf
with the lint brush.
e Pre-tension leaf
v Set the thread guide plate on the machine, inserting
the tenons into the slots. Push the thread guide plate
down to snap it in place.
r Tenon
z
x
c
v
r
w
To Next Page
Loading...
