168
PC-Link:EmbF2 Folder
Ready to import designs from PC.
Connecting the Memory Craft 10001 to a PC
To connect the machine to a PC, you need the
Janome exclusive USB or RS-232C cable
(both sold separately).
Use the USB cable if your PC is Windows 98/
2000/Me/XP base.
Use the RS-232C cable if your PC is Windows
95 or NT base.
Please refer to the Hook-up Diagrams on
pages 170 and 171 for proper connection of
your PC.
Sending the design via PC-Link
You can transfer embroidery design data
between the machine and PC, using
Customizer 10000 Plus or Digitizer 10000
Version 1.3.
After setup is finished, press the PC-Link key
so that the machine is ready to receive data
from the PC.
The screen shows the standby window.
PC-Link Mode
To Next Page
Loading...
