15
TO REPLACE AND ADJUST THE THREADER PLATE
If the needle threader plate is broken or bent, replace it as follows:
To replace:
1. Turn the hand wheel toward you until the needle bar reaches its highest po-sition and lower
the needle threader knob as far as it will go.
2. Loosen screw (A) and replace the needle threader plate (see the Illustration A).
To adjust:
3. If the hook touches the right or left side of the needle eye, loosen screw (A) and move the
needle threader plate (see the Illustration B).
4. If the hook touches the top or bottom of the needle eye, loosen set screw (B) and move the
position set plate (see the Illustration C).
To Next Page
Loading...
