5
TO ADJUST THE PRESSER BAR HEIGHT
The standard presser bar height is 6.0 mm between the bottom surface of the foot and needle
plate when the presser bar lifter is in the position.
1. Open the face plate.
2. Raise the presser foot, loosen the presser bar bracket screw and adjust the height to 6.0
mm.
3. Check if the presser foot is parallel to the openings for the feed dog on the needle plate. If not,
adjust it.
4. Tighten the presser bar bracket screw while holding the presser bar to keep the foot parallel
to the openings.
5. Close the face plate.
To Next Page
Loading...
