7
TO ADJUST THE NEEDLE BAR HEIGHT
The standard distance between the upper edge of the needle eye and the tip of shuttle hook
should be in the range of 1.6-2.0 mm when the tip of shuttle hook meets the right side of the
needle in ascending travel of needle from its left and lowest position.
1. Remove the needle plate & bobbin holder.
2. Turn on the power switch and select the pattern ( ).
3. Turn the hand wheel toward you until tip of shuttle hook meets the right side of the needle.
4. Loosen the needle bar connecting stud set screw.
5. Adjust the height of the needle bar by moving the needle bar upward or downward without
turning it.
(Make sure that the needle setting groove on the needle bar is in the front.
6. Tighten the set screw.
7. Insert the bobbin holder.
8. Attach the needle plate.
To Next Page
Loading...
