Janome Memory Craft 3500 - Table of Contents

CONTENTS
TOP COVER & FACE PLATE ATTACHING AND REMOVING........................................... 1
BASE & BED COVER ATTACHING AND REMOVING ...................................................... 2
BELT COVER ATTACHING AND REMOVING.................................................................... 3
FRONT PANEL ATTACHING AND REMOVING.................................................................. 4
TO ADJUST THE PRESSER BAR HEIGHT ...................................................................... 5
TO ADJUST THE NEEDLE DROP.................................................................................... 6
TO ADJUST THE NEEDLE BAR HEIGHT ......................................................................... 7
TO ADJUST THE HOOK TIMING....................................................................................... 8
TO ADJUST THE CLEARANCE BETWEEN THE NEEDLE AND THE HOOK ................. 9
TO ADJUST THE BACKLASH OF HOOK DRIVE GEAR AND LOWER SHAFT GEAR . 10
TO ADJUST THE FEED DOG HEIGHT ............................................................................11
TO ADJUST THE UPPER SHIELD PLATE POSITION.................................................... 12
TO ADJUST THE UPPER THREAD TENSION ............................................................... 13
TO ADJUST THE STRETCH FEED BALANCE............................................................... 14
TO REPLACE AND ADJUST THE THREADER PLATE.................................................. 15
TO ADJUST THE BUTTONHOLE LEVER....................................................................... 16
BOARD A ATTACHING AND REMOVING ........................................................................ 17
BOARD C ATTACHING AND REMOVING........................................................................ 18
BOARD C AND FUSE ATTACHING AND REMOVING .................................................... 19
DC MOTOR UNIT ATTACHING AND REMOVING ........................................................... 20
TRANSFORMER UNIT ATTACING AND REMOVING ...................................................... 21
MACHINE SOCKET UNIT ATTACHING AND REMOVING ............................................... 22
BUTTONHOLE LEVER ATTACHING AND REMOVING................................................... 23
BOARD K ATTACHING AND REMOVING ........................................................................ 24
BUTTONHOLE SENSOR ATTACHING AND REMOVING ............................................... 25
WIRING DIAGRAM ........................................................................................................... 26
MEMORY CRAFT 3500 DIAGNOSIS CHART .................................................................. 27
MEMORY CRAFT 3500 DIAGNOSIS CHART (NO.2)...................................................... 28
MULTIPLE LANGUAGE FUNCTION ................................................................................. 29