Janome Memory Craft 9450QCP - Extra Wide Table Installation Guide

9
w
q
Adjusting the horizontal position of the thread cutter
switch
z Loosen the setscrews q under the switch.
q Setscrew
w Washer
t
y
r
x Slide the switch to left or right, and x it at the
desired position by tightening the setscrews with a
screwdriver.
Adjusting the vertical position of the thread cutter
switch
z Remove the setscrews q and washers w.
x Move the switch to forward or backward, and attach
the switch to the desired position e and x it
with the setscrews q and washers w.
z
x
w
q
z x
e
NOTE:
To x the thread cutter switch to its lowest position, x
the setscrews into the hole r, and then holes t.
Tighten the setscrews securely.
Peel off the backing paper from the rubber sole y
and attach it to the bottom of the thread cutter switch
as shown.