Janome Memory Craft 9450QCP - Foot Control and Thread Cutter Setup; Attaching Foot Control and Switch; Adjusting Thread Cutter Switch Position

8
Adjusting the thread cutter switch position
Placing the thread cutter switch to the left
The thread cutter switch position can be adjusted for your
convenience.
If you wish to attach the thread cutter switch to the left
side of the foot control, follow the procedure below.
z Remove the setscrews A q, B w and washers e with
a screwdriver.
q Setscrew A
w Setscrew B
e Washer
e
w
e
q
q
w
q
q
z
x
c
x Turn the base plate 180 degrees.
c Attach the foot control and thread cutter switch
with the setscrews and the washers e. Tighten the
setscrews A q and B w. Be sure that the cable is not
caught between the foot control and the base plate.
y
t
r
r
Foot control and Thread Cutter Switch
To attach the foot control q and the thread cutter
switch w to the base plate e, tighten setscrews r, and
setscrews t with washers y as shown.
q Foot control
w Thread cutter switch
e Base plate
r Setscrew A
t Setscrew B
y Washer
q
w
e