Janome Memory Craft 9450QCP - Using the Foot Control

12
Using foot control
If you wish to use the foot control, pull out the cord from
the foot control and insert the pin connector into the jack
on the machine.
z First make sure the power switch q is off.
x Insert the machine plugw of the power supply cable
into the machine socket e.
c Draw out the cord from the foot control and insert the
pin connectorr into thejack t on the machine.
v Insert the power supply plugy into the wall outlet u,
and turn the power switch q on.
q Power switch
w Machine plug
e Machine socket
r Pin connector
t Jack
y Power supply plug
u Wall outlet
NOTE:
The start/stop button does not work when the foot
control is connected.
z
v
q
t
r
w
y
u
e
c
x