Janome QMP16SU - Thread Mast; Hand Wheel; Thread Guides

20 | www.Janome.com
Spool Tray and Thread Mast





Check

over the spool pins.

Tool: #2 Phillips Screwdriver

thread mast. Adjust the thread mast loops directly over the

the screw with the other hand.
Hand Wheel
Check


machine cover, it should not be loose, and there should not be an


Tool: 3 mm hex wrench
1. 
2. Loosen the hand-wheel set screw.
3. 
Thread Guides
See Janome QMP16SU Front Side View
Check




Tool: 2 mm and 2.5 mm hex wrench
• 