QMP16SU Service Manual | 7
Removing the Front Cover
Remove the three small front frame screws
Tools: 3 mm handle hex wrench; may need a 3
mm L-hex wrench to break loose the screws.
1.
2. Use the 3 mm hex wrench to remove the
Remove the thread mast
Tool: 3 mm handle hex wrench
1. Loosen and remove the two screws in the
thread mast.
2. Remove the thread mast.
Loosen or remove the three power plate screws
from the boom of the front cover.
Tool: 2.5 mm handle hex wrench
the machine encoder.
To Next Page
Loading...
