Janome QMP16SU - Thread Tension and Feed Adjustments

QMP16SU Service Manual | 21
Spool Tray and Thread Mast





Check

over the spool pins.

Tool: #2 Phillips Screwdriver

thread mast. Adjust the thread mast loops directly over the

the screw with the other hand.
Hand Wheel
Check


machine cover, it should not be loose, and there should not be an


Tool: 3 mm hex wrench
1. 
2. Loosen the hand-wheel set screw.
3. 
Thread Guides
See Janome QMP16SU Front Side View
Check




Tool: 2 mm and 2.5 mm hex wrench
• 
Top Tension Assembly
See Janome QMP16SU Front Side View, item number 6.
Check #1






Tool: 2 mm and 2.5 mm hex wrench
1. 

2. Remove the knob, detent washer, tension discs, and

3. Clean and reassemble.
Knob removed 

