Janus FM-200 Sv Series - Page 75

Page: 61
FM-200® OPERATION, DESIGN, & SERVICE MANUAL
Revision F
Document # DOC102
Issued: February 1, 2009
Revised: 11-Nov-2011
40YE
Section 4 System Installation
Figure 4.1.6.2 Alternate Pilot Actuation Line Conguration – Utilizing Copper Tubing
(Mv Series Shown. Same for all Series)
Figure 4.1.6.3 Alternate Pilot Actuation Line Conguration – Utilizing Schedule 40 Pipe
(Mv Series Shown. Same for all Series)
Vent Check
(P/N 10173)
Vent Check
(P/N 10173)
10” (254 mm)
Suggested
Height
1/4” (8 mm)
NPT Pipe Plug
(Provided By
Installer)
1/4” (8 mm) Male
45°SAE Flared x
Male NPT
Adapter Nipple
(Provided By
Installer)
1/4” (8 mm) Male 45°SAE
Flared x Male NPT Tee
(Provided By Installer)
Pilot Actuation
End Line Tee
(P/N 18611)
1/4” (8 mm) O.D.
Copper Tubing
(Provided By Installer)
1/4” (8 mm)
Schedule 40 Pipe
(Provided By Installer)
NPT Style Pilot
Actuation Check Valve
(P/N 10262)
Pilot Actuation Check
Valve
(P/N 18560)
1/4” (8 mm) Female
NPT x Male 45° SAE
Flared Adapter
(Provided By Installer)
Pilot Actuation Adapter
(P/N 18624)
Sv Series Only
Pilot Actuation Adapter
(P/N 18624)
Sv Series Only
NPT Pilot Actuation Check
Valve Adapter Hex Nipple
(Sv Series: P/N 18713)
(Mv and Lv Series: P/N 19192)
Primary
Cylinder
Primary
Cylinder
Slave
Cylinder
Slave
Cylinder
Slave
Cylinder
Slave
Cylinder
Slave
Cylinder
Slave
Cylinder
Slave
Cylinder
Slave
Cylinder
24” Flex Hose
(610 mm)
(P/N 18649)
24” Flex Hose
(610 mm)
(P/N 18649)
Male NPT
Adapter
(P/N 18625)
Male NPT
Adapter
(P/N 18625)
1/4” (8 mm) Female
NPT x Female NPT Tee
(Provided By Installer)