Jasic MIG160PFC - Page 40

Page 40
(Select spool torch)
1) After connecting the spool torch with the welder, select the "Spool Torch" mode of the
welding torch type.
2) When the remote control function is enabled, the "Wire Feed Speed" is adjusted by the
potentiometer of spool torch.
3) When the remote control function is disabled, the "Wire Feed Speed" is adjusted by the
"Parameter Adjustment Knob A" on the operation panel of welder.
4) For details about other panel operations, see sections 7.12-7.14.
Note! The "Synergic" function is disabled when using the "Spool Torch" mode.
If there is no potentiometer on the spool torch, the "Spool Torch" is selected and the
remote control function is enabled, the current will be unable to be adjusted.
Note! Some models do not support spool torch function. Please confirm with the
seller whether the machine supports this function before purchasing.
7.1.6 Start welding
Description of MIG 2T/4T operation
2T operation mode
4T operation mode
Step 1: Press the torch trigger to start
welding.
Step 1: Press the torch trigger for the first time to
start welding.
Step 2: Release the trigger to stop
welding.
Step 2: Release the trigger for the first time to
continue welding.
Step 3: Press the trigger for the second time to
resume welding.
Step 4: Release the trigger for the second time to
stop welding.