To select parameters, the user needs to first rotate the encoder to select "Parameter Settings";
then press the encoder to enter the "Parameter Settings" page; rotate the encoder to locate
the parameter to be adjusted; and press the encoder again to adjust the parameter value.
After adjustment, press the encoder to exit adjustment. The adjustment steps are as follows:
For example: If the user wants to adjust the operating mode in SynMIG, use the master
encoder to select and enter the "Parameter Settings" page, select "Operating Mode" and then
select between 2T and 4T. The selected operating mode will change from gray to green. If
selected, press the master encoder and a "√" will appear after the option, indicating that the
option is valid. After the above operation, the user can rotate the master encoder to select
other parameters or options, or press "Back" to return to the upper-level menu. If no operation
is performed within 3s, the welder will automatically return to the SynMIG home page.
To Next Page
Loading...
