Jayco PINNACLE - Page 129

119
PLUMBING SYSTEM
7. After the recommended amount of sanitizing solution is in the tank; the water tank
LVIXOOWKHFDUWULGJHZDWHU¿OWHULIVRHTXLSSHGLVE\SDVVHGRUWKH¿OWHULVUHPRYHG
IURPWHUZDWHU¿OSRZHUWRZDWHUKHDWHUVKRXOGEH2))ERWKVZLWFKHVHOHFWULF/3
gas). When the fresh water tank is full; set the valves
to the DRY CAMPING setting. Turn the pump ON and
VDQLWL]HGZDWHUZLOOÀRZLQWRWKHZDWHUOLQHVIURPWKHWDQN
8. Open all hot water faucets one by one until water begins to
ÀRZFRQWLQXRXVO\DQGDFKORULQHVPHOOLVQRWLFHDEOH,QFOXGHRXWVLGHVKRZHUIDXFHWVLI
so equipped). Close hot water faucets.
9. 2SHQDOOFROGZDWHUIDXFHWVRQHE\RQHXQWLOZDWHUEHJLQVWRÀRZFRQWLQXRXVO\DQG\RX
smell chlorine. Include the outside shower faucets (if so equipped). Close cold water
faucets.
10. Turn OFF the water pump.
11. Let the solution remain in the tank and lines for at least four hours when disinfecting
with 50-PPM residual chlorine. If a shorter time period is desired, then a 100-PPM
chlorine concentration should be permitted to sit in the system for at least one hour.
12. After the required period, drain the chlorine solution from the fresh water system (see
Draining the Fresh Water System).
Rinse the system with fresh water:
13. Fill the fresh water tank full of clean (potable) water. Use water from either a pressurized
source, or from a container (as detailed below).
a. Filling from a pressurized source: Set the valves to the POWER FILL TANK
setting. Connect a non-toxic drinking hose to the city water connection inlet.
Connect the other end of the hose to the pressurized water source. Turn on the
water source. When tank is full, turn off the water
VRXUFHGLVFRQQHFWWKHKRVHIURPWKHZDWHUVRXUFH¿UVW
then disconnect from the utility panel.
b. 6\SKRQ¿OOLQJIURPDZDWHUFRQWDLQHU: Set the valves to the SANITIZE setting.
Insert a hose into the city water connection inlet; place the other end of the hose in
a container of water. Turn the pump ON to draw water into the tank. After the tank
is full, turn the pump OFF. Remove the hose and the container. To aid in siphoning
place the container on a surface approximately (2) feet
off the ground. Drain valves must be off.
NOTE: To thoroughly sanitize the fresh water tank, the unit should
be driven around for a period of time allowing the solution to splash
the sides and top of the tank
Table
of
Contents
Table of Contents
Maintenance
Record
Maintenance Record