Jayco PINNACLE - Page 130

120
PLUMBING SYSTEM
14. Power to water heater should be OFF (both switches: electric & LP GAS). When the
fresh water tank is full, set the valves to the DRY CAMPING setting. Turn the pump
ON to send water through the lines.
15. Run water through all faucets (hot & cold, including outside shower) until chlorine
smell is gone. Turn faucets and outside shower off, turn pump OFF.
16. Then, drain the fresh water system again. (see Draining the Fresh Water System). If the
59KDVWKHIXOOV\VWHPFDQLVWHUZDWHU¿OWHUUHPRYHWKHFDQLVWHUUHLQVWDOOWKH¿OWHUDQG
reattach the canister.
17. 5H¿OOWKHIUHVKZDWHUWDQNZLWKIUHVKZDWHUDJDLQDQGZKHQZDWHUKHDWHULVIXOORIZDWHU
WXUQWKHZDWHUKHDWHUSRZHU215HIHUWR6WHSIRULQVWUXFWLRQVRQUH¿OOLQJWKHIUHVK
water tank.
Lingering Chlorine Taste:
,IDFKORULQHWDVWHOLQJHUVLQWKHZDWHUÀXVKWKHZDWHUV\VWHPZLWKDVROXWLRQFRQVLVWLQJRI
RQHTXDUWYLQHJDUWR¿YHJDOORQVRIFOHDQZDWHU5HÀXVKDVQHFHVVDU\7KHYLQHJDUVROXWLRQ
PD\GDPDJHWKHZDWHUKHDWHURUWKHZDWHU¿OWHUso both must be bypassed again before
performing this operation.
Follow the steps outlined in Draining the Fresh Water System with one exception, do not
drain the water heater. Do not remove the water heater drain plug.
)RUWKHIXOOV\VWHPFDQLVWHUZDWHU¿OWHU:UHPRYHWKHFDQLVWHUWDNHRXWWKH¿OWHUWKHQUHDWWDFK
the empty canister.
After draining the system:
1. Water heater power should still be OFF. (both switches: electric & LP Gas)
2. Put the vinegar solution into the fresh water tank; set the valves to the SANITIZE
VHWWLQJ$WWDFKD KRVHWRWKH FLW\ZDWHU ¿OOLQOHW 3XWWKH RWKHU HQGRI WKHKRVHLQ D
container with the vinegar solution. Turn the pump ON. The solution will be drawn
into the fresh water tank (the water heater will be bypassed automatically). When
the container is empty, turn pump OFF, and disconnect hose
from utility panel. To aid in siphoning, place the container
approximately (2) feet off the ground. The drain valves must
be closed.
3. Fill the fresh water tank full of clean (potable) water. Use
water from either a pressurized source, or from a container (as detailed below).
a. Filling from a pressurized source; Set the valves to the POWER FILL TANK
VHWWLQJ&RQQHFWDQRQWR[LFGULQNLQJKRVHWRWKHFLW\ZDWHU¿OOLQOHW&RQQHFW
the other end of the hose to the pressurized water source.
Turn on the water source. When tank is full, turn off
the water source, disconnect the hose from the water
VRXUFH¿UVW, then disconnect from the utility panel.
b. 6\SKRQ¿OOLQJIURPDZDWHUFRQWDLQHU set the valves to the SANITIZE setting.
,QVHUWDKRVHLQWRWKHFLW\ZDWHU¿OOLQOHWSODFHRWKHUHQG
of the hose in a container of water. Turn pump ON to
draw water into the tank. After the tank is full, turn the