10
Setting the date and time
1: Turn the power on (hold button
down for 2 seconds) and set the
video recorder to the Setup Menu.
2: Press the UP or DOWN button to
select [Date&Time..] then press
the SHUTTER/ OK or RIGHT
button to launch the submenu.
3: Press the UP or DOWN button to change the highlighted value. Press
the LEFT or RIGHT button to move the cursor between settings.
4: Press the SHUTTER/ OK button to confirm the setting.
5: Press the MENU button to close the menu.
Note that after replacing batteries you need to reset the time / date
again.
To Next Page
Loading...
