JBL Authentics L16 User Manual

Operation
9
Authentics L16
7. JBL Authentics will then attempt to connect to
your Wi-Fi Network (the LED shall flash during the
connection process).
Once connected successfully, the LED will stop
flashing and an audio tone will be heard.
You can connect your computer or phone/tablet to the same
Wi-Fi network as Authentics and enjoy your music wirelessly.
Operation
Turning the JBL Authentics L16 ON and OFF
To turn the JBL Authentics L16 ON, press the Power button
on the top panel of the system.
To put the system into Standby mode, again press the Power
button.
NOTE: You can toggle between the Standby and the
Operational modes by pressing the Power button.
Adjusting the System’s Volume
Rotate the Volume tuner on the panel of the system clockwise
to increase and counter-clockwise to decrease the volume.
The white LEDs around the Volume tuner indicate the volume
level of the audio system. The system has 40 steps and 12 is
the default volume level. All the voice prompts will be played
at the default level.
NOTE: When the system goes into Operational mode
from Standby, the volume set during the Operational
mode before it went to Standby becomes the default
volume level.
IMPORTANT: The lowest setting of the volume tuner
will mute the system.
Muting the System
To mute the JBL Authentics system:
• Set the volume to level 0 by rotating the Volume tuner
counterclockwise.
NOTE: There are no other means to mute the audio
system.
Switching Sources
Press the JBL Authentics L16 Source button for up to two
seconds to cycle between the sources in the following
sequence:
1. AirPlay
2. DLNA
3. Bluetooth
4. Aux Input
5. Phono
6. Digital Optical
The system can play only one active source at a time. Press
the Source button whenever you want to change the source.
The system has an auto-switch function to switch sources
automatically. If you attempt to connect to another source
while the system is in operational mode with one source, the
system stops or pauses the audio from the last source.

JBL Authentics L16 Specifications

General

Product color	Walnut
Housing material	Wood
Recommended usage	Universal
Suitable for outdoor use	No
Tweeter	Yes
Speaker type	3-way
Tweeter diameter	25 mm
Number of drivers	6
Speaker placement	Tabletop/bookshelf
Audio output channels	1.0 channels
Woofer diameter (imperial)	5.25 \
Tweeter diameter (imperial)	1 \
Mid-range driver diameter (imperial)	2 \
Amplifier output power	300 W
Impedance	- Ω
Sensitivity	108 dB
Frequency range	35 - 35000 Hz
RMS rated power	- W
Signal-to-Noise Ratio (SNR)	98 dB
Total Harmonic Distortion (THD)	0.1 %
Equalizer	-
Headphone outputs	1
Headphone connectivity	3.5 mm
USB 2.0 ports quantity	2
Connectivity technology	Wired & Wireless
Power source type	AC

Weight and Dimensions

Width	- mm
Weight	- g