EasyManuals Logo

jcb 3CX Service Manual

jcb 3CX
890 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #245 background imageLoading...
Page #245 background image
37 - 1
Fault Finding
Introduction
The fault finding procedures are given in the form of flow
charts. There are a number of charts, each one dedicated to
a particular fault. The charts are designed to identify
possible causes by performing checks and where
applicable, specific tests. Having identified a cause the
suggested remedy is given. The charts are designed to
identify causes through a process of elimination, starting
with the simplest, most easily rectified faults.
Before proceeding:
1 Make sure that the hydraulic fluid is at the correct
working temperature (50
o
C, 122
o
F).
2 Be sure to remove ALL contamination and if possible
identify its origin. It may be part of a component from
elsewhere in the circuit.
3 Replace any seals such as ‘O’ rings before assembling
hydraulic components.
Fault Finding Charts:
Chart A - No Servo Controls (system fails to operate)
Chart B - All Backhoe Services Slow to Operate
Chart C - One Backhoe Service fails or is Slow to Operate
Chart D - System Fails to Operate when the ‘Mode Switch’
is Activated (operator seat facing forward)
Section D Controls
9803/3280
Section D
37 - 1
Issue 1
Precision Control (Servo)
www.WorkshopManuals.co.uk
Purchased from www.WorkshopManuals.co.uk

Table of Contents

Other manuals for jcb 3CX

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the jcb 3CX and is the answer not in the manual?

jcb 3CX Specifications

General IconGeneral
Brandjcb
Model3CX
CategoryCompact Loader
LanguageEnglish

Related product manuals