20 Fit the planet carrier onto the bearing carrier, ensuring
that the two tapped holes are in line with those on the
bearing carrier. Fit and torque tighten screws A to
56Nm (41Ibf ft; 5.7kgf m) after applying JCB Lock and
Seal to the threads.
Note: Do not strike the centre of the planet gear carrier when
fitting as this may dislodge the driveshaft thrust pad fitted at
step 17.
Re-fill hubs with the correct grade oil.
81 - 10
Section F Transmission
9803/3280
Section F
81 - 10
Issue 1
Front Axle - SD55, SD70
Hub and Driveshaft - Assembly (cont'd)
S258220
A
To Next Page
Loading...
