Operation
Transporting the Machine
81 81
9811/5700-7
Putting the Mast into the Transport Position
With the machine safely in position on the trailer, the park
brake engaged and the transmission in neutral, do the
following:
1 Unfasten both tilt cylinder restraint wires from the
mast.
a Unscrew and remove bolt A and washer B from
each mast tilt cylinder pivot pin.
b Remove the restraint wires C (if fitted).
Fig 64.
2 With the engine running, operate the controls to raise
the carriage 200mm (8 in) from it's lowest position.
3 Tilt the mast fully forward. Make sure the forks do not
foul on the trailer bed. K
Fig 65. ( T 81).
Fig 65.
To Next Page
Loading...
