CHAPTER 2 Operations and Maintenance
2 - 25
It is important to keep the bill bath, rollers, and belts clean. The sensor lenses are transparent, and made of
polymer material. Handle them with care.
To clean the lenses, use a lint-free cloth and mild nonabrasive detergent such as liquid dish soap mixed with
water.
<!> Do not use alcohol or thinner for cleaning.
(1) Pull the tabs on both sides of the acceptor forwarded to open the acceptor's head.
(2) Open the acceptor head front and rear covers to clean bill path, rollers and belts.
Note: JCM does not recommend cleaning cards,
cleaning pads, or cleaning solutions of any kind.
Preventive Maintenance (P/M)
Do periodic P/M on acceptor’s head and stacker unit to ensure proper operation. Use compressed air to blow
out the paper fibers and other debris that builds up over time. Check the belts and all moving parts for wear
and proper positioning. If the unit does not operate properly, it can cause bill jams.
After completing P/M, Auto-Calibration is recommended (See Chapter 7).
9. Cleaning / Preventive Maintenance
To Next Page
Loading...
