JDE PROFESSIONAL CAFITESSE QUANTUM TOUCH - 2.7 Replacement of Worn Parts; 2.8 Disposing of the Packaging Material; 2.9 Disposal of the machine

13
2- SAFETY INSTRUCTIONS
QUANTUM TOUCH
Disposal of the machine should be in accordance with regional disposal regulations.
The machine is subject to the Waste Electrical and Electronic Equipment Directive (WEEE/EU directive)
and can not be mixed with normal domestic waste.
Do not release the compressed refrigerant into the atmosphere without authorization, reclamation
by an authorized person may be required. If refrigerator gas reclamation is required, this must be
done by a licensed, qualied individual.
Please observe that the CAFITESSE QUANTUM TOUCH contains components that are subject to wear
by liquids through normal usage even if the machine is maintained under the stipulated service
procedures. This particularly includes mechanical components and parts that are in contact
with hot water by liquids, such as hoses, seals, valves etc.
Defects caused by natural wear by liquids, are deemed not to be subject to warranty
or guarantee. Defective parts should however always be replaced by an authorized service
technician, trained by the manufacturer.
2.8 Disposing of the Packaging Material
2.9 Disposal of the machine
2.7 Replacement of Worn Parts
Warning
Warning
The packaging is made from various recyclable materials. It is recommended that
the packaging material is retained for future transport.
If you wish to dispose of the packaging material after installation, please recycle
or dispose of materials in an environmental manner.
Defects caused by natural wear by liquids, are deemed not to be subject to warranty
or guarantee.