WARNING ALERTS
Rear Distance
(in/cm)
Greater than
79 in (200 cm)
79-39 in
(200-100 cm)
39-25 in
(100-65 cm)
25-12 in
(65-30 cm)
Less than
12 in (30 cm)
Audible Alert
Chime
None Single 1/2
Second Tone
Slow Fast Continuous
Display Message Park Assist ON Warning Object
Detected
Warning Object
Detected
Warning Object
Detected
Warning Object
Detected
Arcs None 3 Solid
(Continuous)
3 Slow
Flashing
2 Slow
Flashing
1 Slow
Flashing
Radio Mute No Yes Yes Yes Yes
NOTE:
ParkSense姞 will MUTE the radio, if on, when
the system is sounding an audio tone.
Enabling And Disabling ParkSense姞
ParkSense姞 can be enabled and disabled with
a switch located in the switch bank of the
instrument panel or through the Customer-
Programmable Features section of the EVIC.
The available choices are: OFF, Sound Only, or
Sound and Display. Refer to “Electronic Vehicle
Information Center (EVIC)/Personal Settings
(Customer-Programmable Features)” in “Un-
derstanding Your Instrument Panel” for further
information.
When the ParkSense姞 switch is
pressed to disable the system, the
instrument cluster will display the
“PARK ASSIST OFF” message for
approximately five seconds. Refer
to “Electronic Vehicle Information
Center (EVIC)” in “Understanding Your Instru-
ment Panel” for further information. When the
shift lever is moved to REVERSE and the sys-
tem is disabled, the EVIC will display the “PARK
ASSIST OFF” message for as long as the
vehicle is in REVERSE.
The ParkSense姞 switch LED will be ON when
ParkSense姞 is disabled or defective. The Park-
Sense姞 switch LED will be OFF when the
system is enabled.
Service The ParkSense姞 Rear Park
Assist System
When the ParkSense姞 Rear Park Assist System
is malfunctioning, the instrument cluster will
actuate a single chime, once per ignition cycle,
and it will display the “SERVICE PARK ASSIST
SYSTEM” message. Refer to “Electronic Ve-
hicle Information Center (EVIC)” in “Under-
standing Your Instrument Panel” for further in-
formation. When the shift lever is moved to
103
To Next Page
Loading...
