Jeep CHEROKEE - Front Turn Signal Lamp; Front Fog Lamp; Side Repeater Lamp; Rear Tail;Stop, Turn Signal, Back-Up and Fog Lamps

5. Install new bulb into housing.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
6. Latch spring retainer to headlamp bulb.
7. Install rubber seal and electrical connector
to the headlamp bulb.
Front Turn Signal Lamp
1. Turn the steering wheel all the way to the
right to access the left front turn signal. Turn the
steering wheel all the way to the left to access
the right front turn signal.
2. Remove three push-pins from the wheel-well
liner.
3. Gently flex the wheel-well liner forward to
access the bulb.
4. Rotate the bulb’s socket counterclockwise,
and remove the bulb and socket assembly from
the turn signal housing.
5. Pull the bulb out of the socket and insert the
replacement bulb.
6. Install the bulb and socket assembly into the
turn signal housing, and rotate the socket
clockwise to lock it in place.
7. Reposition the wheel-well liner and install
the push-pins.
Front Fog Lamp
1. Open the hood.
2. Reach behind the headlamp housing to
access the bulb.
3. Rotate the bulb’s socket counterclockwise,
and remove the bulb and socket assembly from
the fog lamp housing.
4. Pull the bulb out of the socket and insert the
replacement bulb.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
5. Install the bulb and socket assembly into the
fog lamp housing, and rotate the connector
clockwise to lock it in place.
6. Close the hood.
Side Repeater Lamp
1. Push the side repeater lens to the right side
to release the spring tension and then pull it
outward.
2. Disconnect the bulb from the harness con-
nector and then connect the replacement bulb.
3. Engage the left hook of the side repeater
lamp into the sheet metal (note correct orienta-
tion of lettering on lens).
4. Rotate the side repeater lamp in place until
the right side engages (you will hear a light
click).
Rear Tail/Stop, Turn Signal, Back-Up
And Fog Lamps
1. Open the liftgate.
2. Remove the screws that fasten the taillamp
housing to the vehicle.
257