Cav-
ity
Car-
tridge
Fuse
Mini-
Fuse
Description
M37 — 10 Amp
Red
Antilock Brakes/
Stability Control
System Module/
Stop Light Switch/
Fuel Pump Relay
M38 — 25 Amp
Natural
Door and Liftgate
Lock/Unlock Mo-
tors
CAUTION!
• When installing the Integrated Power Mod-
ule cover, it is important to ensure the cover
is properly positioned and fully latched.
Failure to do so may allow water to get into
the Integrated Power Module, and possibly
result in an electrical system failure.
(Continued)
CAUTION! (Continued)
• When replacing a blown fuse, it is important
to use only a fuse having the correct am-
perage rating. The use of a fuse with a
rating other than indicated may result in a
dangerous electrical system overload. If a
properly rated fuse continues to blow, it
indicates a problem in the circuit that must
be corrected.
REPLACEMENT BULBS
LIGHT BULBS – Interior Bulb No.
Cargo Lamp ...............TS578
Overhead Console Lamp .....PLW214–2A
Reading Lamp ..........HTV-14VC1A
LIGHT BULBS – Exterior Bulb No.
Headlamp...................H4
Front Turn Signal Lamp .......PY27/7W
Front Position Lamp............W5W
Side Repeater Lamp...........WY5W
Back-Up Lamp .............P27/7W
Center High Mounted Stop Lamp
(CHMSL) ..................LED
(serviced at authorized dealer)
Front Fog Lamp ...........H109145
License Plate Lamp ............W5W
Rear Tail/Stop..............P27/7W
Rear Turn Signal Lamp .......PY27/7WK
BULB REPLACEMENT
Headlamp
1. Open the hood.
2. Reach behind the headlamp housing and
remove the electrical connector and rubber
seal, from the headlamp bulb.
3. Unlatch spring retainer from headlamp bulb.
4. Pull bulb outward from assembly.
256
To Next Page
Loading...
