averaging will continue from the last fuel aver-
age reading before the reset.
• Distance To Empty (DTE)
Shows the estimated distance that can be
traveled with the fuel remaining in the tank. This
estimated distance is determined by a
weighted average of the instantaneous and
average fuel economy, according to the current
fuel tank level. DTE cannot be reset through the
FUNCTION SELECT button.
NOTE:
Significant changes in driving style or ve-
hicle loading will greatly affect the actual
drivable distance of the vehicle, regardless
of the DTE displayed value.
When the DTE value is less than 30 miles
(48 km) estimated driving distance, the DTE
display will change to a text display of ⬙LOW
FUEL.⬙ This display will continue until the ve-
hicle runs out of fuel. Adding a significant
amount of fuel to the vehicle will turn off the
⬙LOW FUEL⬙ text and a new DTE value will
display.
• Elapsed Time
Shows the total elapsed time of travel since the
last reset. Elapsed time will increment when the
ignition switch is in the ON or START position.
• Display Units of Measure in:
To make your selection, press and release the
FUNCTION SELECT button until “ENGLISH” or
“METRIC” appears.
To Reset The Display
Reset will only occur while a resettable function
is being displayed. Press and release the
FUNCTION SELECT button once to clear the
resettable function being displayed. To reset all
resettable functions, press and release the
FUNCTION SELECT button a second time
within three seconds of resetting the currently
displayed function (reset ALL will display dur-
ing this three-second window).
Compass Display / ECO
(Fuel Saver Mode) — If Equipped
COMPASS Button
The compass readings indicate
the direction the vehicle is facing.
Press and release the COMPASS
button to display one of eight com-
pass readings and the outside
temperature.
NOTE:
The system will display the last known out-
side temperature when starting the vehicle
and may need to be driven several minutes
before the updated temperature is dis-
played. Engine temperature can also affect
the displayed temperature; therefore, tem-
perature readings are not updated when the
vehicle is not moving.
ECO (Fuel Saver Mode) — If Equipped
The ECO message will display below the out-
side temperature in the EVIC display. This
message will appear whenever you are driving
in a fuel efficient manner.
135
To Next Page
Loading...
