Jelrus Infinity M-30 - Page 17

Tostartimmediately,pressSTART/STOP
Followthesameprogrammingproceduresifathreeorfourstageprogramisdesired
PressNIGHTTIME(DELAYSTART)tostartanovernightburnout(SeeSAMPLEONSTAGEPROGRAMtopro-
gramNIGHTTIME(DELAYSTART)time
NOTE: When the temperature is set to a lower temperature than in the previous stage,
the furnace ignores the programmed HEAT RATE (except for "NO") and
automatically cools to the pre-set temperature. The time required for the cooling
stage is determined by the pre-set temperature. The lower the temperature,
the more time needed to cool down.
OPERATION
HEAT RATE
TEMP
HOLD TIME
STAGE 1
STAGE 2
STAGE 3
STAGE 4
10°F(6°C)
1600°F(871°C)
1:00
NO
NO
*
*
*
*
*Thoughanynumbermayappear,theunitisdeactivatedwhen“NO”isselectedfortheHEATRATE
20°F(11°C)
600°F(316°C)
30
16
SAMPLE THREE STAGE PROGRAM
(ProgramwithCooling)