E17
BASS BOOST
Press the BASS BOOST BUTTON (#16) to enable bass boost function if you want more bass
effect when listening. BASS icon will light on the LCD DISPLAY #11). Press BASS BOOST
BUTTON (#16) again to turn off bass boost function. BASS icon will be turned off.
AUXILIARY INPUT
This unit provides an auxiliary audio signal input jack for connecting external audio
devices like MP3 players, CD players and older, non-dockable iPods (except iPod
shuffle 3
rd
gen) so you can listen to your external source through the speakers of this
system.
1. Use an audio cable (not included) with one 3.5 mm stereo plug on each end of the
cable.
2. Plug one end into the AUX-IN jack on the main unit and the other end of the cable into
the Line-out Jack or Headphone Jack of your external audio device.
3. Turn on the external audio device.
4. To select auxiliary audio input, press the FUNCTION button to select AUX mode.
5. The volume level can now be controlled through the main unit. Operate all other
functions on the auxiliary device as usual.
Note:
(1) If the Line Out Jack of your external device is connected, then you only need to adjust
the volume control of this system. If the Headphone Jack of your external device is
connected, then you may need to adjust both the volume control of your external
device and the volume control of this system to find the most desirable volume
setting.
(2) Slide the MODE SWITCH to turn off the system when you finish listening. Don't forget
to switch off the power on your external device as well.
SLEEP OPERATION
The SLEEP TIMER feature allows you to turn off the unit automatically after a designated
time has elapsed.
1. Select CD, FM/AM, Bluetooth or AUX Mode and begin playing music from the
selected source.
2. Tap the SLEEP BUTTON (#10) to enter sleep mode.
3. Repeatedly tap the SLEEP BUTTON (#10) to select the sleep timer 10 – 20 – 30 –
40 – 50 – 60 – 70 80 – 90 - OFF (in minutes). The unit will play for the selected
length of time then turn off automatically.
4. To cancel the sleep timer, repeatedly tap the SLEEP BUTTON (#10) until the timer
shows OFF.
5. To turn the unit “Off” before the selected length of time, press POWER BUTTON
(#7) at any time.
Note: Tap the SLEEP BUTTON (#10) once to check the remaining sleep time.
DIMMER OPERATION
Tap the DIMMER BUTTON (#19) repeatedly to select the brightness settings of the
display (Low or High).
To Next Page
Loading...
