33
CMR2724 INFORMATION
Please read all instructions carefully before attempting to install or
operate.
Due to its technical nature, it is highly recommended that your JENSEN CAR2724 is installed by a
professional installer or an authorized dealer. This product is only for use in vehicles with 12VDC
negative ground only.
To prevent damage or injury:
• Make sure to ground the unit securely to the vehicle chassis ground.
• Do not remove the top or bottom covers of the unit.
• Do not install the unit in a spot exposed to direct sunlight or excessive heat or the possibility
of water splashing.
• Do not subject the unit to excessive shock.
• When replacing a fuse, only use a new one with the prescribed rating. Using a fuse with the
wrong rating may cause the unit to malfunction.
• To prevent short circuits when replacing a fuse, disconnect the wiring harness rst.
• Use only the provided hardware and wire harness.
• You cannot view video while the vehicle is moving. Find a safe place to park and engage the
parking brake.
• If you experience problems during installation, consult your nearest JENSEN dealer.
• If the unit malfunctions, reset the unit as described on page 10 rst. If the problem still
persists, consult your nearest JENSEN dealer or call tech assistance @ 1-888-921-4088.
• To clean the monitor, wipe only with a dry silicone cloth or soft cloth. Do not use a sti cloth,
or volatile solvents such as paint thinner and alcohol. They can scratch the surface of the
panel and/or remove the printing.
• When the temperature of the unit falls (as in winter), the liquid crystal inside the screen will
become darker than usual. Normal brightness will return after using the monitor for a while.
• When extending the ignition, battery or ground cables, make sure to use automotive-grade
cables or other cables with an area of 0.75mm (AWG 18) or more to prevent voltage drops.
• Do not touch the liquid crystal uid if the LCD is damaged or broken. The liquid crystal uid
may be hazardous to your health or fatal. If the liquid crystal uid from the LCD contacts your
body or clothing, wash it o with soap immediately.
Safety Notice