Jensen DL500 - 5 Step guide to getting started; Switch on;off; DAB+ operation; FM operation

35
Switch on/off
1. Press and release the ‘ ’ button
on the front of the radio�
DAB+
1. Press and release the ‘Mode’
button until you are in DAB mode�
2. Press and hold the ‘Scan’ button
to scan for DAB stations�
3. Use the left hand rotary control
to move through the station list�
4. Press and release the left hand
rotary control to ‘Select’ when
the station you would like to
listen to is displayed�
5. Adjust the volume using the
right hand rotary control�
FM
1. Press and release the ‘Mode’
button until you are in FM mode�
2. Press and release the ‘Scan’
button to scan for FM stations,
your radio will stop at the next
available station�
3. Use the left hand rotary control
tonetuneeachfrequency.
4. RDS information for each
station will be displayed, if
available�
5. Adjust the volume using the
right hand rotary control�
Bluetooth
1. Press and release the ‘Mode’
button until you are in Bluetooth
mode�
2. The product will be in pairing
mode and the bluetooth indicator
and symbol on the display will
ashforupto3minutes.
3. On the device that you would
like to connect to your radio
via Bluetooth (e�g� iPhone/iPad/
Android/other phone/Computer),
turn on Bluetooth connectivity
and ensure that it is ‘discoverable’�
Note: If necessary, refer to the
instructions for your device to
add or set up Bluetooth�
4. When found, the bluetooth
connection to your radio will be
displayed as ‘Jensen DAB’� Select
the device name to begin pairing�
5. When pairing is complete, the
bluetooth symbol (next to
theclock)willstopashingand
remain on continuously�
5 Step guide to getting started