Jensen DL500 - Scanning for DAB stations

38
Scanning for DAB stations
With DAB radio, additional
stations and services regularly
become available so it’s a good
idea to carry out a scan every
now and then to make sure that
you have the most up to date
station listing stored within the
memory of your radio�
If you have moved your radio to
another location, e�g� if you go on
holiday, then it’s also a good idea
to carry out a scan�
1. If you are not already in DAB
mode, press and release the
‘Mode’ button on the front of
your radio to go to DAB mode�
2. Press and hold the ‘Scan’ button
on the front of your radio to
carry out scan� ‘Scanning’, will
be displayed and a progress bar
will show the progress of the
scan and the number of stations
found during the scan will also be
displayed�
Note: See ‘Changing DAB
stations’ on page 9 for how to
change DAB stations after a scan�
Secondary services
You may see a ‘>’ symbol after
the name of a DAB station� This
indicates that there are secondary
services available on that
station, e�g� a sports station with
additional commentaries�
To select the secondary service,
turn the left hand rotary control
clockwise when the ‘>’ appears in
the display� When the secondary
service ends, your radio will
automatically go back to the
primary station�
Manual tune
Using the manual tune feature
youcanselectaspecicdigital
radio channel frequency and then
manually adjust the aerial, or the
location of the radio, to get the
strongest possible signal for that
channel in your location�
1. Press and hold the ‘Info/Menu’
button on the front of the radio
until ‘<Full scan>’ is displayed�
2. Use the left hand rotary
control to scroll to ‘<Manual
tune>’� Press the left hand rotary
control to ‘Select’�
3� Turn the left hand rotary
control to scroll through the
digital radio frequencies� Stop
when the frequency you would
like to listen to is displayed� Press
the left hand rotary control to
‘Select’�