Jensen XA4200 - 2 CH;3 CH;4 CH Input Modes; 4 Channel; 2 Channel; 3 Channel

XA4200, XA4300
JENSEN
2CH/3CH/4CH
2 Channel
The XA4200/XA4300 can be configured for three
different input modes: 4 channel, 3 channel or
2 channel.
4 Channel
2CH
3CH
4CH
When the input selector is set to
4 CH, the amplifier will operate as
a standard 4 channel amp with all
RCA inputs connected.
3 Channel
When the input selector is set to
3 CH, the amplifier is configured for
stereo/mono operation. The front
channels of the amplifier operate in
stereo mode. The rear channels of
the amplifier are internally bridged
for mono operation. In 3 CH the
following RCA inputs will be used:
0
B
2CH When the input selector is set to
3CH
4CH
2 CH, the amplifier is configured for
bridged stereo operation. The
amplifier will need a two channel
input even though there are four
inputs. In the 2 CH the following
inputs will be used:
Note
Although the above illustrations indicate the
low level input being used, the same
connections would apply to the high level
input.
High Inputs
11