14
CONTROL PANEL
START
ON/OFF
WASH
READY
185
160
RINSE
PRESSURE
GAUGE
ON/OFF
WASH
RINSE
A
B
C
D
E
F
G
H
B
C
D
E
F
G
H
I
A: Pressure gauge
B: Start button
C: Power switch button
D: Wash water temperature
E: Rinse water temperature
F: Cycle pilot light
G: Ready temperatures pilot light
H: Power pilot light
I: Drain button
BASIC STEPS TO START
Begin with an empty dishwasher, no water in the wash tank. It is easier to start this way.
Make sure the screens and the overflow pipe are in place.
Close the door.
Push the round grey button (C). The dishwasher will take about two minutes to fill and 20 minutes to
heat up the water. Do not open the door during fill, water will spray out.
The booster will heat up first and then the wash tank will heat up.
When the dishwasher is ready, the ready light will come on (G). This indicates that the dishwasher has
reached maximum temperatures.
You can now start washing.
Fill the basket with dishes.
Slide it in to the dishwasher.
Close the door and press the round grey button(B). The dishwasher will start washing for a few
minutes and than will rinse for about half a minute.
When the cycle light (F) goes off, open the door and remove the tray to let air dry.
You’re ready for another wash. You do not have to wait for the ready light to light again (G). As long as
the temperatures are within parameters (150°F to 165°F for wash and 180°F to 190°F for rinse), it is
okay to wash.
You should drain the dishwasher at least once a day, and the dishwasher should be turned off and left
empty of water at night.
To drain the dishwasher, follow these simple steps;
Turn Off the power.
Open the door, reach in and pull the overflow tube out(water may be hot). Water will drain out like a
sink.
For machine equipped with a drain pump, press and hold the gray drain button (I) until all the water is
gone. Be careful not to let any dirt go down the drain as it may block the pump.
To Next Page
Loading...
