11
WATER SUPPLY
- Water supply must be 140° F (60°C) at all time.
If water temperature is 130°F or less, the unit will not meet NSF standards and the dishwasher must be
allowed an extra two (2) minutes between washes cycles.
- Running pressure must not exceed 30 PSI (15 PSI on the gauge). A Pressure Regulating Valve
maybe required.
- Water should be free of minerals and other sediments.
- Hook-up is made with ¾ NPT. It is recommended to use the metal breaded reinforced hose supplied with the
machine.
- If a hot water tank has to be installed to supply the dishwasher, the average rate of water consumption is 30 gallons
per hour (110 Litres/hour).
- A water shut-off valve is required near the machine (3 feet, or 1 meter).
- Make sure to tighten your water connections snugly to prevent leaks from developing, but do not over tighten.
NOTE: Do not rely on the pressure gauge on the machine. This pressure gauge shows internal pressure only. It will
show a pressure of about 15 PSI if 30 PSI is applied to the machine.
F-14
F-16DP
F-18DP
Water connection is 3/4 NPT. A flexible fill hose is supplied
with this unit. Needs 30 PSI (2 Bar), 140°F (60°C). The
water connection is located at the rear of the machine,
behind the stainless steel panel. The hose can either come
out the left or right side. The pressure gauge on the
machine should show 15 PSI during flow.
Water connection is 3/4 NPT. A flexible fill hose is supplied
with this unit. Needs 30 PSI (2 Bar), 140°F (60°C). The
water connection is located at the rear of the machine. The
hose can either go to the left or right side of the machine.
The pressure gauge on the machine should show 15 PSI
during flow.
Water connection is 3/4 NPT. A flexible fill hose is
supplied with this unit. Needs 30 PSI (2 Bar), 140°F
(60°C). The water connection is located at the rear of
the machine. The hose can either go to the left or right
side of the machine. The pressure gauge on the
machine should show 15 PSI during flow.
Water In
Water In
Water In
F-22
Water connection is 3/4 NPT. A flexible fill hose is supplied
with this unit. Needs 30 PSI (2 Bar), 140°F (60°C). The
water connection is located inside of the machine, at the
base, next to the wash-pump. The flexible hose will come
out the back of the machine. The pressure gauge on the
machine should show 15 PSI during flow.
Fill Hose
To Next Page
Loading...
