6
Installation Guidelines
This commercial dishwashing machine must be installed by licensed technicians. All utilities
must comply with local codes. If you need a list of qualified technicians, please call our
office.
It is important to carefully unpack the machine and inspect as soon as it is received. Any
damage must be reported immediately. All packing material should be well
discarded. The plastic protective sheets covering the stainless must be removed.
Do not use the wood pallet on which the unit was shipped as a stand. Taller legs and
metal stands are available.
The unit must be installed on a hard, level surface or allow for easy levelling of the
unit. Enough room should be allowed around the unit to allow for servicing. The units come equipped
with hoses, ready to connect and install. The electrical wire (except for the F-14) needs to be supplied
by the electrician and will be “hard-wired” on a dedicated circuit.
Some models are equipped with automatic drain pump.
The dishwasher must be installed on a non-combustible surface. Installation on hard-wood
floor is forbidden.
All Panels must remain on the equipment when the installation is finished.
The unit can become very hot. Keep away from children.
Using this unit will cause a small amount of water to spill on the floor when the basket is
removed from the wash cabinet, making the floor slippery. The floor near the unit should have
a non-slippery surface, or anti-skid.
A floor drain near the unit is recommended.
This instruction Manual must remain with the operator. The operator must read this manual.
This unit must be registered upon installation for the warranty. MVP Group will send a technician
(some condition applies) free of charge to verify the unit and the installation.
To Next Page
Loading...
