8
Removing Panels
cont.
F-18DP
A)The front bottom panel needs to be removed
to access the chemical pumps.
To connect the electrical wire it will be
necessary to access the inside of the machine.
The panels should be removed in a specific
sequence.
1) using a phillips screw driver, remove the two
screws located at the back of the top panel.
2) Once removed, the panel should slide
towards the back and pulled up.
3) the rear panel is held by three phillips
screws, at the bottom of the panel.
4) the panel must be lifted up and pull away.
1
2
3
A
F-22
A)The front bottom panel needs to be removed
to access the chemical pumps.
To connect the electrical wire it will be
necessary to access the inside of the machine.
The connection is made in the control panel
situated on the right side of the machine. four
(4) phillips screws need to be removed to
access it. The panel will slide as a drawer (B).
Pull gently on the bottom edge of the panel.
The drawer should extend about 20 centimeter
(8 inches).
A
B
To Next Page
Loading...
