Jet JWB-10 - Troubleshooting JWB-10 Band Saw

14
12.0 Optional Accessories
Stock no. Application Length Width Thickness TPI
707201 Scrollwork 67.5 in. 0.125 in. 0.025 in. 18TR
707202 Resaw 67.5 in. 0.5 in. 0.032 in. 4HK
707203 General purpose 67.5 in. 0.5 in. 0.025 in. 6HK
707204 General purpose 67.5 in. 0.25 in. 0.025 in. 6SK
13.0 Troubleshooting JWB-10 Band Saw
Symptom Possible Cause Correction
Saw stops or will not
start
Saw unplugged Check plug connections
Fuse blown, or circuit breaker tripped Replace fuse, or reset circuit breaker
Cord damaged Replace cord
Does not make
accurate 45
o
or 90
o
cuts
Stop not adjusted correctly Check blade with square and adjust stop
Angle pointer not set accurately Check blade with square and adjust pointer
Blade wanders during
cut
Fence not aligned with blade Check and adjust fence
Warped wood Select another piece of wood
Excessive feed rate Reduce feed rate
Incorrect blade for cut Change blade to correct type
Blade tension not set properly Set blade tension according to blade size
Guide bearings not set properly Review guide bearing adjustment
Saw makes
unsatisfactory cuts
Dull blade Replace blade
Blade mounted wrong Teeth should point down
Gum or pitch on blade Remove blade and clean
Incorrect blade for cut Change blade to correct type
Gum or pitch on table Clean table
Blade does not come
up to speed
Extension cord too light or too long Replace with adequate size and length cord
Low shop voltage Contact your local electric company
Saw vibrates
excessively
Base on uneven floor Reposition on flat, level surface
Bad v-belt Replace v-belt
Motor mount is loose Tighten motor mount hardware
Loose hardware Tighten hardware
14.0 Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-800-
274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and Serial Number of
your machine available when you call will allow us to serve you quickly and accurately.
Non-proprietary parts, such as fasteners, can usually be found at local hardware stores, or may be ordered from
JET.
Some parts are shown for reference only, and may not be available individually.