Why doesn't board thickness match the scale on my Jet Planer?
If the board thickness doesn’t match the thickness scale on your Jet Planer, it’s likely that the thickness scale is out of adjustment. Recalibrate the thickness scale/cursor and make test cuts to correct this.
Why does the chain keep coming off the sprocket(s) on my Jet JWP-13BT Planer?
If the chain keeps coming off the sprocket(s) on your Jet Planer, it may be because the chain or sprocket(s) are worn. Inspect them and replace as needed.
General| Minimum Material Thickness | 5 mm |
|---|---|
| Number of Knives | 2 |
| Voltage | 230 V |
| Planing Width | 330 mm |
| Maximum Material Thickness | 152 mm |
Essential safety practices applicable to all machinery operation.
Critical safety check for cutterhead knife security before operation.
Essential procedures for proper electrical grounding to prevent shock.
How to raise or lower the cutterhead for desired cutting depth.
Using the gauge to set the desired depth of cut for planing.
Setting the planer to achieve precise final workpiece thickness.
Checking and replacing the sharp cutterhead knives for safe operation.
Step-by-step guide for feeding material through the planer.
How to safely turn the planer on, off, and use the safety key.
Inspecting and replacing motor carbon brushes for optimal motor function.
Steps for replacing worn or damaged drive belts.
Fine-tuning the thickness gauge stop for precise cuts.
To Next Page
