JETWAY NP591 - Page 34

29
Parity
The default setting is: [None].
*This item may or may not show up, depending on different configuration.
Stop Bits
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
 PC Health Status
Press [Enter] to view current hardware health status and set value in ‘Shutdown
Temperature’.
Shutdown Temperature
Use this item to select system shutdown temperature.
The optional settings are: [Disabled]; [70
o
C/156
o
F]; [75
o
C/164
o
F]; [80
o
C/172
o
F];
[85
o
C/180
o
F]; [90
o
C/188
o
F].
 CPU Configuration
Press [Enter] to view current CPU configuration and make settings for the following
sub-items:
Limit CPUID Maximum
The optional settings: [Disabled]; [Enabled].
This item should be set as [Disabled] for Windows XP.
Intel Virtualization Technology
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], a VMM can utilize the additional hardware capabilities
provided by Vanderpool Technology.
EIST
The optional settings: [Disabled]; [Enabled].
Use this item to enable or disable Intel SpeedStep.
CPU C State Report
Use this item to enable or disable CPU C state report to OS.
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following item shall appear: