Section 7—Lubrication and Maintenance
7-18 31211031
Fuel System
A. Fuel Level Check
1. Check Fuel Gauge (7) located in right side of Instrument Panel in cab.
2. If fuel is low, proceed to fuel source and perform “Shut-Down Procedure” on page 4-5.
3. Turn fuel tank cap (8) to remove from filler neck.
4. Add fuel as needed.
5. Replace fuel tank cap.
Note: Replenish diesel fuel at end of each work shift to minimize condensation.
NOTICE
EQUIPMENT DAMAGE. Do not allow machine to run out of fuel during operation. See
Engine Operation & Maintenance Manual for details prior to servicing.
To Next Page
Loading...
