SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
31217162 6-17
Safety Prop
THE SAFETY PROP MUST BE USED WHENEVER MAINTENANCE PERFORMED ON THE
MACHINE REQUIRES THE SCISSOR ARMS TO BE RAISED.
The red safety prop is located at the rear of the machine in the
armstack. To engage the safety prop:
1. Ensure there is no load in the platform. From the ground
controls station, raise the platform enough to allow the
safety prop to be engaged.
2. Pull the ring to release the safety prop, then pull the prop
down until it hangs vertically.
3. Lower the platform until the safety prop rests on the cross-
shaft below.
4. To disengage, lift up the platform, pull the ring to release the
prop, then lower the platform.
1. Release Ring
2. Safety Prop
To Next Page
Loading...
