SECTION 1 - SAFETY PRECAUTIONS
1-4 31217162
Trip and Fall Hazards
• Prior to operation, ensure all gates and rails are fastened and
secured in their proper position.
• JLG Industries, Inc. recommends that all persons in the plat-
form wear a full body harness with a lanyard attached to an
authorized lanyard anchorage point while operating this
machine. For further information regarding fall protection
requirements on JLG products, contact JLG Industries, Inc.
• Identify the designated lanyard anchorage point(s) at the plat-
form and securely attach the lanyard. Attach only one (1) lan-
yard per lanyard anchorage point.
• Enter and exit only through gate area. Use extreme caution
when entering or leaving the platform. Ensure that the plat-
form assembly is fully lowered. Face the machine when enter-
ing or leaving the platform. Always maintain “three point
contact” with the machine, using two hands and one foot or
two feet and one hand at all times during entry and exit.
.
• Keep both feet firmly positioned on the platform floor at all
times. Never position ladders, boxes, steps, planks, or similar
items on unit to provide additional reach for any purpose.
• Never use the scissor arm assembly to gain access to or leave
the platform.
• Keep oil, mud, and slippery substances cleaned from footwear
and the platform floor.
To Next Page
Loading...
