Jntech JNP22KH-V5 - Page 64

64
information items are located.
The following describes the operation information, basic information, pump
information, statistical information, and fault information.
8.3.1.1 operation information
The items in the operation information show the current operation information
of the inverter. The following table explains each item in detail.
Figure8-3 The meaning of main interface parameters
RunInfo
Introduction
Vdc
Inverter input voltage (V).
Ipv
Inverter input current (A).
Ppv
Inverter input power (W).
State-AC
Current grid status of inverter (online/offline).
Pgrid
Inverter current grid input power, unit W.
Igrid
Inverter current grid input current (DC side), unit A.
Fout
Inverter output current frequency (Hz).
Iuout
Inverter output U phase current (A).
Ivout
Inverter output V phase current (A).
Iwout
Inverter output W phase current (A).
Temp
Inverter radiator temperature, unit ℃ .
Errcode
Inverter current fault code.
Stopcode
Stop code, can query the last stop code of the inverter,
according to the stop code can query the cause of the inverter
stop.
S-Mode
Automatic/manual start and stop mode.
D-Mode
Inverter dry mode detection/automatic
0F-F
Selection of water overflow alarm function in water storage
device of photovoltaic water pump system.