53
Figure 7-1 Motor Parameters’ Detection Interface
Note！
In some special occasion, re-detection of motor parameters is required, such as
change pump, the “DebugMode” should be changed to 6, then press “DOWN”
and “ENTER” at the same time to return to the first screen, and begin detect.
7.4.2 Commission
7.4.2.1 Self-detect motor parameter
After finishing motor parameters’ detection, LCD screen will indicate” Test finish start up?
YES/NO”, select “YES”, and inverter will start; select “NO”, inverter will stay in motor
detection model, and re-detect when start it again.
To Next Page
Loading...
